Technical Specifications
The following specifications are important and vital to the correct operation of this product. Failure to adhere to the specifications will result in any warranty or guarantee that was provided becoming null and void.
|
Ordering Information |
|
|---|---|
|
PRT-WX-DIN-IP |
Protege WX DIN Rail Integrated System Controller (IP only) |
|
Power Supply |
|
|
Operating Voltage |
11-14V DC |
|
Operating Current |
120mA (Typical) |
|
DC Output (Auxiliary) |
10.45-13.85V DC 0.7A (Typical) Electronic shutdown at 1.1A |
|
Bell DC Output (Continuous) |
10.4-13.45V DC 8 ohm 30W Siren or 1.1A (Typical) Electronic shutdown at 1.6A |
|
Bell DC Output (Inrush) |
1500mA |
|
Total Combined Current* |
3.4A (max) |
|
Electronic Disconnection |
9.0V DC |
|
Communication |
|
|
Ethernet |
10/100Mbps ethernet communication link |
|
RS-485 |
3 RS-485 communication interface ports - 1 for module communication, 2 for reader communication |
|
USB |
Type-A |
|
Readers |
|
|
Readers |
2 reader ports, independently configurable for either Wiegand (up to 1024 bits configurable) or RS-485, allowing connection of up to 4 readers providing entry/exit control for two doors ** |
|
RS-485 reader port connections support configuration for OSDP protocol |
|
|
Inputs |
|
|
Inputs (System Inputs) |
8 high security monitored inputs |
|
Outputs |
|
|
Outputs |
4 (50mA max) open collector outputs for reader LED and beeper or general functions |
|
Relay Outputs |
2 Form C relays - 7A N.O/N.C. at 30V AC/DC resistive/inductive |
|
Dimensions |
|
|
Dimensions (L x W x H) |
156 x 90 x 60mm (6.14 x 3.54 x 2.36") |
|
Net Weight |
348g (12.3oz) |
|
Gross Weight |
|
|
Operating Conditions |
|
|
Operating Temperature |
|
|
Storage Temperature |
-10˚ to 85˚C (14˚ to 185˚F) |
|
Humidity |
0%-93% non-condensing, indoor use only (relative humidity) |
|
Mean Time Between Failures (MTBF) |
560,421 hours (calculated using RDF 2000 (UTE C 80-810) Standard) |
* The total combined current refers to the current that will be drawn from the external power supply to supply the expander and any devices connected to its outputs. The auxiliary outputs are directly connected via thermal resettable fuses to the N+ N- input terminals, and the maximum current is governed by the trip level of these fuses. The Bell output is connected in the same way.
** Each reader port supports either Wiegand or RS-485 reader operation, but not both at the same time. If combining reader technologies, they must be connected on separate ports.
The size of conductor used for the supply of power to the unit should be adequate to prevent voltage drop at the terminals of no more than 5% of the rated supply voltage.
Integrated Control Technology continually strives to increase the performance of its products. As a result these specifications may change without notice.